What usually goes wrong
- The motor runs but the chain or belt does not move. On many chain and belt openers the main drive gear is nylon. After fifteen years it wears down to white shavings inside the cover. A gear and sprocket kit is a standard repair.
- The motor hums for a second and stops. Often the start capacitor. It is a small part, and replacing it can bring an older motor back.
- The door starts down and reverses, and the light blinks. The photo eyes are out of line, dirty, or have a damaged wire. Start with the safe checks guide. Many of these are fixed with a rag.
- The remote works only from a few feet away, or not at all. Try a fresh battery first. LED bulbs in the opener that were not made for openers can also jam the radio signal.
- Nothing at all, no light, no click. Check the outlet with a lamp and check the GFCI. If the outlet is live and the opener is dead after a storm, the logic board likely took a surge.
- The opener runs and the trolley moves, but the door stays. The red release cord has been pulled. Re-engage the trolley and try again.
One more cause sits outside the opener. If the door suddenly feels too heavy for the motor, the problem may be a broken spring. An opener should never be asked to lift a door with a broken spring.
Repair it or replace it
Openers typically last 10 to 15 years, and plenty in Springfield garages are past 20. Age matters for three reasons beyond wear.
- Federal rules have required photo eyes or an equivalent safety sensor on every opener made since January 1, 1993. A unit older than that has no eyes and should be replaced, not repaired.
- Openers from before the mid-1990s use a fixed radio code that can be copied. Newer units use rolling code, which sends a different code on every press.
- Parts for older models get harder to find each year, and a repair can cost half the price of a new opener.
A fair rule: if the opener is under ten years old and the fix is a gear, a capacitor or a sensor, repair it. If it is past fifteen and needs a logic board or a motor, put the money toward a new one. Local homeowners say the techs they recommend are the ones who repaired an opener that another company wanted to replace, so ask for both prices.
Choosing a new opener
The main choice is the drive. Chain drives cost the least and make the most noise. Belt drives are quiet enough for a garage with a bedroom over it. Wall-mount units, which the trade calls jackshaft openers, bolt beside the door and turn the spring shaft directly, which frees the ceiling and suits high-lift tracks. The opener types guide compares them.
Ask about battery backup. Missouri does not require it, but the Ozarks lose power often enough to make it worth a few dollars more. The January 2007 ice storm left parts of the Springfield area dark for days, and the April 2025 wind storm caused the worst outages since. A battery gets you a couple of dozen cycles with the power out.
What it typically costs
| Job | Typical range |
|---|---|
| Opener repair (gear kit, capacitor, sensor, limit adjustment) | Typical range$100 to $300 |
| Photo eye replacement | Typical range$85 to $300 |
| New chain drive opener, installed | Typical range$300 to $500 |
| New belt drive opener, installed | Typical range$330 to $650 |
| New wall-mount (jackshaft) opener, installed | Typical range$550 to $950 |
A new opener price should include taking down and hauling off the old unit, new photo eyes, a wall button, at least one remote, and setting the travel and force limits. Ask whether it does. Reusing old sensors and wall wire is a common shortcut.
Keypads, remotes and phones
A wireless keypad that has stopped responding usually needs a 9-volt battery or reprogramming. Remotes are matched to the opener's brand and year, so bring the model number when you ask about a replacement. Most openers sold now connect to Wi-Fi so you can check and close the door from your phone. Older units can often be made to do the same with an add-on hub.
Opener repair: questions
Why does my opener light blink ten times?
On many common openers, ten blinks means the photo eyes are blocked or out of line. Check that both sensor lights near the floor are solid, wipe the lenses, and make sure nothing is in the beam. If one sensor light flickers, it has been bumped.
Is it worth fixing a 20-year-old opener?
Usually only if the fix is cheap, such as a capacitor or a gear. A unit that old lacks current security features, and parts for it are scarce. Get the repair price and the replacement price and compare.
How much horsepower do I need?
A half horsepower opener handles a standard steel double door when the springs are right. Heavy wood doors, insulated oversized doors and 8-foot-tall doors do better with three-quarter horsepower or the DC motor equivalent.
Can a new opener work with my old door?
Yes, as long as the door is balanced and moves freely by hand. A new opener on a door with worn springs or binding rollers will not last. A good installer checks the door first.
