How a door ends up off its track
- Something was in the way. A trash can or a bumper under one corner stops that side while the other keeps moving. The slack cable unwinds off its drum and the door racks sideways.
- A car hit it. Even a gentle tap bends the bottom of the vertical track enough to let a roller escape.
- A cable frayed and snapped. Cables fail at the bottom bracket, where water and road salt off the car sit on the floor all winter.
- A spring broke on a two-spring door. The side with the good spring pulls harder, and the door goes up crooked.
- The track worked loose. The lag screws that hold the track brackets to the framing back out over years of vibration.
What the repair involves
The tech first makes the door safe, usually by clamping the track and taking the tension off the springs. Then the door is squared in the opening, the rollers are set back in the track, and the cables are rewound evenly on both drums. Bent track gets straightened if the bend is mild and replaced if it is creased, since a creased track will let the roller out again.
A careful tech then looks for the reason it happened. A door does not usually leave the track for no cause. Expect them to check the cables for broken strands, spin each roller, look at the hinges on the end of each section, and test the balance.
Rollers and hinges
A 7-foot door rides on 10 rollers and an 8-foot door on 12. Builder-grade doors often ship with plastic rollers that have no bearings. They wear oval and get loud, and in time they wobble enough to jump the track. Nylon rollers with sealed ball bearings are the common upgrade, and swapping a full set is one of the cheaper ways to quiet a door.
The bottom rollers sit in the bottom brackets, which are tied to the lift cables and are under spring tension. Those two are not a do-it-yourself swap. Hinges crack too, most often at the center of a double door where the opener arm pushes and pulls.
What it typically costs
| Job | Typical range |
|---|---|
| Door put back on track and realigned | Typical range$200 to $350 |
| Cable replacement | Typical range$150 to $350 |
| Roller replacement, full set | Typical range$100 to $240 |
| Section of track replaced | Typical range$125 to $300 |
If a vehicle did the damage, take photos before anything is moved. Whether it is worth an insurance claim depends on your deductible. A track and cable repair often comes in under it. Panel replacement is the part that pushes a claim over the line.
What you can safely do
Unplug the opener so nobody runs it by habit. Keep kids, pets and cars away from the door, especially if it is stuck partway up. Do not try to push the door back into the track or pry the cable back onto the drum. The cable is carrying spring tension, and the door weighs more than it looks.
Off-track repair: questions
Can I still use the door if only one roller is out?
No. With one roller out, the load shifts to the hinges and rollers next to it, and each cycle makes it worse. Leave the door where it is.
Why did my cable come off?
Most often the door came down on something and the cable went slack, or the cable has frayed at the bottom. A broken spring on one side can also unload a cable. The tech should find the cause, not only rewind it.
Should I replace all the rollers at once?
If they are the original plastic ones and one has failed, yes. The parts are cheap and most of the cost is the visit.
My door is stuck open and crooked. What now?
Do not stand under it and do not pull the release. Unplug the opener, keep the area clear, and tell the tech it is stuck open so they bring what they need to secure it.
