The four seals on a garage door
- Bottom seal. A rubber or vinyl strip that slides into a retainer on the bottom edge of the door and compresses against the floor. It takes the most wear and is the one usually replaced.
- Side and top seals. Vinyl flaps on the stop molding around the outside of the opening. Sun hardens them until they curl away from the door.
- Threshold. A raised rubber strip glued to the floor under the door. It is used when water runs toward the garage.
- Section joints. The tongue-and-groove joints between sections on better doors, which close up as the door comes down.
When the slab is the problem
Garage floors settle and crack, and Ozarks clay moves with the seasons. If one corner of the door touches the floor and the other shows an inch of daylight, a standard seal will not close the gap. The usual fixes are a larger bulb seal that compresses unevenly to fill the low side, or a threshold on the floor.
First have the tech confirm that the door itself is level. A door that sits crooked because one cable has stretched is a cable problem, not a floor problem.
Ice, and doors frozen to the floor
Meltwater off the car runs to the door and freezes the seal to the slab overnight. When the opener pulls on a frozen door, it either reverses or tears the seal out of its retainer. If the door will not lift on a freezing morning, pull the release and try to break it free by hand with a push at the bottom, or pour warm water along the seal. Do not keep hitting the button.
Sweeping standing water out before a hard freeze prevents most of it. A cracked or flattened seal holds more water and freezes harder.
Adding insulation to an existing door
A single-layer steel door can be insulated from the inside with foam board or a fitted kit. It helps with temperature and cuts the drumming noise a hollow door makes. Two cautions. Insulation adds weight, sometimes 20 pounds or more on a double door, and the springs were sized for the door without it. Have the balance checked afterward and the springs adjusted or resized. Also, a kit will not reach the R-value of a factory-insulated door, and it does nothing for stiffness.
If the door is older and already needs work, compare the cost of a kit plus spring adjustment against a new insulated door. Factory doors with polyurethane foam reach R-12 to R-18. Board kits land well below that.
What it typically costs
Replacing the full perimeter weatherstripping on a 16x7 door runs about $200 to $600 in national cost surveys, with a bottom seal alone at the low end or below it. The part is inexpensive. Most of the price is the visit, so it makes sense to have seals done during a tune-up or another repair. These are general market figures, not a quote.
Be cautious if a seal request turns into a long list of other parts. Seals wear out long before the rest of the door does.
Weather seals: questions
Can I replace the bottom seal myself?
Often, yes. If the door has an aluminum retainer with channels, the old seal slides out and the new one slides in with some dish soap for lubricant. The hard part is matching the profile. Older wood doors use a nailed-on seal.
Why is there a gap on one side of my garage door?
Either the floor is uneven or the door is not level. Check the door with a level across the bottom section when it is open a foot. If the door is level, the floor has settled and a larger seal or threshold will close the gap.
Will sealing the door keep mice out?
It helps a great deal. Mice need a gap of about a quarter inch. The usual entry points are the bottom corners, where the seal meets the track, so ask the tech to look there in particular.
Is an insulated garage door worth it in Missouri?
For an attached garage, generally yes. Winters here are cold enough and summers hot enough to notice, and an insulated door is quieter and resists dents. For a detached, unheated garage the payoff is small.
